€ 39,00
Taxas não incluidas: € 32,23
Descrição
The Zipato smoke sensor is designed to give warning when smoke is detected. Indeed, when the latter detects smoke, a powerful audible alarm is triggered, and a Z-Wave signal is sent to the main controller.
It is therefore possible to create different scenarios triggered by this alert.
This detector is a Z-Wave Plus product and therefore supports all the features offered by the 500 series chipset.
A Z-Wave controller (remote control, dongle, home automation box, ...) is necessary to integrate this detector into your network if you already have an existing network.
FUNCTIONS
- Z-Wave 500 Series
- Audible Alert and Z-Wave on Smoke Detection
- Low energy consumption
- Low automatic battery ratio
- Ease of installation
TECHNICAL CHARACTERISTICS
- Protocol: Z-wave Plus (868.42MHz)
- Power supply: CR123A battery, 1400mAh
- Operating Voltage: 3V
- Operating Current: 90mA
- Operating Temperature Range: -10 ° C to + 50 ° C
- Radio range: 30m
- Dimensions: 60 x 60 x 50mm
- Weight: 132g
- Standards: EMC 2004/108 / EC, R & TTE 1995/5 / EC, LVD 2006/95 / EC, FCC Part 15
MANUAL
Especificação
| Compatibilidade controlador principal | |
|---|---|
| eeDomus+ | Not Tested |
| Fibaro Home Center 2 v4.160 | Not Tested |
| Fibaro Home Center Lite v.4.160 | Not Tested |
| Vera Edge / Plus / Secure | Not Tested |
| Zipabox/Zipaminicro/ZipaTile | Full Compatible |
| Piper / Piper NV (v.1.7.1) | Not Tested |
| Indigo | Not Tested |
| jeedom | Not Tested |
| Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | Not Tested |
| Domoticz | Not Tested |
| ZiHome | Not Tested |
| Somfy Tahoma | Not Tested |
| Home Assistant | Not Tested |
| Telldus | Not Tested |
| Tech Data | |
| FLiRS | No |
| Power Supply | CR123A 1400mAh |
| Explorer Frames - NWI Support | No |
| SDK | 6.51.08 |
| App Version | FW: 1.10 |
| Device Type | Notification Sensor / Reporting Sleeping Slave |
| Z-Wave Alliance Product Link | https://products.z-wavealliance.org/products/1936 |
| Procedures | |
| Incluison | - Click [Add] icon in Z-Wave PC Controller Program. - Press the Net_Button 3 times within 1.5s, Green LED is Blinking 3 times within 1 second. - If Inclusion Process is successful, Green led will turn off. |
| Exclusion | - Click [Remove] icon in Z-Wave PC Controller Program - Press the Net_Button 3 times within 1.5s - If Exclusion Process is successful, Green led is Blinking 6 times, then turn off. |
| Factory Reset | -Long press Net_Button while installing batteries in HS1SA-Z. - Device Reset Locally notification is Transmitted. -Please use this procedure only when the network primary controller is missing or otherwise inoperable. |
| Wake Up | - Wake up Notification is transmitted every 24 hours by default. - Wake up Notification is transmitted after Notification Report is Transmitted |
