Z-Uno - Z-Wave Board for Arduino Z-Wave.me

59,49

Taxas não incluidas: € 49,17

Disponibilidade:
Em Stock
Código do produto:
ES-11-ZMEEZUNO
Fabricantes:
Z-Wave Me

Descrição

Z-Uno is the first and only easy to use developer board that allows you to create your own Z-Wave device without deep knowledge of Z-Wave protocol or programming. Z-Uno is a mix of Z-Wave home automation radio protocol power and Arduino simplicity. Being inspired by Arduino project Z-Uno inherits all concepts of easy-to-use hardware and software solutions, keeping maximum flexibility.

Z-Uno is a fully DIY product. It is made for those who are limited by existing choice of Z-Wave products and wants to extend their smart homes with more sensors and actuators: connect LEDs, buttons, switches, motors or any low voltage sensor including most of Arduino compatible sensors.

Z-Uno programming is done by writing sketch in simplified C language and loaded into Z-Uno using Arduino IDE. Many examples and comprehensive tutorials will help you to make your own project.

Being Z-Wave Plus certified device, Z-Uno is the perfect companion for you RaZberry gateway. Z-Uno is compatible with other controllers too: among them Fibaro Home Center 2/Lite, Vera Edge and Zipato Zipabox.

http://z-uno.z-wave.me/news/

Especificação

Compatibilidade controlador principal
eeDomus+ Full Compatible
Fibaro Home Center 2 v4.160 Not Tested
Fibaro Home Center Lite v.4.160 Not Tested
Vera Edge / Plus / Secure Not Tested
Zipabox/Zipaminicro/ZipaTile Not Tested
Piper / Piper NV (v.1.7.1) Not tested
Indigo Not tested
jeedom Full Compatible
Z-Wave.me / Z-Way / PoPP Hub Full Compatible
Domoticz Not tested
OpenHAB Not tested
ZiHome Not tested
Tech Data
Power Supply USB 5 V, external 5V or 3 V, external 7-18 V or battery (via MU-2F connector, included)
Attachable Loads Defined by user: http://z-uno.z-wave.me/examples/Certified10Channels/
Explorer Frames - NWI Support Yes
SDK 6.51.06
Device Type Always On Slave
Z-Wave Alliance Product Link http://products.z-wavealliance.org/products/1825
Procedures
Incluison Press Service button three times
Exclusion Press Service button three times
Factory Reset Hold Service button for five seconds, then press Service button three times. Use this procedure only if your controller is missing or inoperable. Note that the user sketch is not erased during exclusion or reset process.

Perguntar

Fazer uma pergunta ou comentário

Obs: HTML não é suportado!

Mau            Bom


Continuar

Z-Wave Portugal

A loja online que vende soluções para a automação das habitações através das redes sem fios e do protocolo Z-Wave. Z-Wave é o standard internacional para as redes sem fio dos sistemas de controlo para habitações. Com base nestas soluções pode gerir a iluminação, a electricidade, os estores, os alarmes e muito mais, optimizando a utilização destes meios. Os produtos Z-Wave, mesmo os de diferentes fabricantes, funcionam bem em conjunto permitindo o controlo efectivo da casa inteligente.

Contact Us

Móvel:
+351 919655531
email:
info@z-wave.pt
Skype:
ar.alexandre.ramos

Twitter

Facebook